Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Allis 112 transmission won't go in gear


dougpat_2000

Recommended Posts

clutch releases but transmission won't shift in gear. All linkage is hooked up and shift leaver is alligned with the given slot but it won't rotate into the given gear. HELP Thanks Dougpat
Link to comment
Share on other sites

Does it grind if you try to go into gear without the clutch? If it does maybe the problem is at the axles and not the trans, see if the axle tube spins. If not check for a sheared key on the input shaft pulley, if that seems fine a teardown maybe required.
Link to comment
Share on other sites

No it doesn't grind but the shaft won't rotate into any gear. This seams to me that it doesn't mesh in there. My problem is I have never worked on any of these transmissions so all I can do is guess. I was hoping that someone out there was familar with this setup. Dougpat
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...