Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
Fred

Kent's been at it again, and it looks good!

Recommended Posts

Fred
Hey all, go look at the tune-up Kent gave to the "What's New" page. Pretty sharp Kent, and it's a good place to check now and then, especially to see the new pictures that are posted.
As I became member #40 when I gave myself to the club as a Christmas present, I'm particularly proud of what Kent said about the occasion.
"Dec 26, 1998 Membership in Club goes over 40, a milestone!"
Too bad Kent's spelling is so poor. That should be "millstone", as in around the neck.
Fred

Share this post


Link to post
Share on other sites
Fred
You're up to the plate Sir, Jack This surely deserves a response from you! All I will say is who's neck is this 'mill/milestone around...Hmmm? And BTW good job as always Mr. Kent!! DLC AKA CLOCKWATCHER

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • Bill725
    • goodtimo
    • SmilinSam
    • PhanDad
    • tadams
    • John Dyer
    • Jjsmachines
    • simplewrench
  • Today's Birthdays

    1. JoggerFogger
      JoggerFogger
      (49 years old)
  • Recent Status Updates

    • Paul M.Murphy

      Paul M.Murphy

      Hello glad I got on this site. I hope to upload a couple of photos of my Simplicity Broadmoor 
      Model 707 Tractor. I have replaced all the belts on it and installed a new ignition switch.
      Have a mower deck which was in poor shape , repaced a couple of bushings and welded the
      deck where there was some holes. The tractor and mower deck came from a friend and the 
      mower deck metal was getting pretty thin. Some new metal was put in it and we also undercoated the underside of the deck. This was done by my friend Greg Toulman.
      I have not put the mower deck on the tractor yet, waiting for Greg to come home and give me a hand. Can you please tell me if there is a manual for the mower deck and where I could get one.
      I would also like to get some moon wheel discs as well.
      I will try and down load some photos of the tractor when my wife shows me how to. 
      I really love driving this tractor and also how well it is made compare today's tractors, especially the flexible rear end and the rollers.
      Tell the next time 
      Paul
       
      · 8 replies
    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
  • Adverts

×