Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Need throttle rod length for Briggs


JDSnyder

Recommended Posts

I am moving right along on restoration of my Landlord 101. It has a Briggs #243431 10hp engine that someone disconnected the governor on. I need the length of the linkage rod that runs from the governor bar to the carburetor. It would be easy to fashion one if I knew the exact length from connecting point to connecting point. If someone has the information or could please measure theirs, I would appreciate it. I promise to send pictures to Kent when I am finished. Thanks, Jeff Snyder
Link to comment
Share on other sites

Jeff, I have a 243431 Briggs on my Big Ten Allis and the throttle rod is exactly 7 inches from the surface on the bottom of the governor arm hole to the top of the throttle arm hole. It has a couple of major kinks in it to clear the carburetor bowl and the pivot bolt for the upper governor arm. Ron Carter
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...