Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  


Recommended Posts

Also, how long does it take to mount the snowblower on the 912? Tools needed? Engineering degree? Please Lord, help me, WHY AM I GOING TO BUY THIS OLD TRACTOR WHEN THERE ARE ALL KINDS OF NICE NEW ONES IN DIFFERENT SHADES OF GREEN AND YELLOW, RED?????? ARGHHHHHHH!!!!!!!!

Share this post

Link to post
Share on other sites
Going to look at a used 912G (1980) again tomorrow (discussed in earlier post). Know what to look for on the tractor but need advice on what to check out on the snowblower. Again, asking price is $1500 for the two. Thinking about offering $1000 and then going $1200 tops. Any thoughts appreciated.

Share this post

Link to post
Share on other sites
Brett, you cannot find an easier mounting snowblower than the one for the 912 except manybe the older AC and Sim. It requires no tools once the blower is set up properly.
The blower is pretty simple, just a high speed spinning auger. Just look at the general condition of the blower if it is all bent up it could have other problems. Make sure the auger spins freelly. It should have three pulleys with it. One under the top guard and two pivoting. One should have a spring (belt tensioner) on it.
Good Luck. MS

Share this post

Link to post
Share on other sites
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • Brian Shires
    • B10Dave
    • Alltractoredup
    • AC716
    • Hick
    • Talntedmrgreen
    • SmilinSam
    • kwt
    • rokon2813
    • Bill725
  • Today's Birthdays

    1. littlefan
      (60 years old)
  • Recent Status Updates

    • Paul M.Murphy

      Paul M.Murphy

      Hello glad I got on this site. I hope to upload a couple of photos of my Simplicity Broadmoor 
      Model 707 Tractor. I have replaced all the belts on it and installed a new ignition switch.
      Have a mower deck which was in poor shape , repaced a couple of bushings and welded the
      deck where there was some holes. The tractor and mower deck came from a friend and the 
      mower deck metal was getting pretty thin. Some new metal was put in it and we also undercoated the underside of the deck. This was done by my friend Greg Toulman.
      I have not put the mower deck on the tractor yet, waiting for Greg to come home and give me a hand. Can you please tell me if there is a manual for the mower deck and where I could get one.
      I would also like to get some moon wheel discs as well.
      I will try and down load some photos of the tractor when my wife shows me how to. 
      I really love driving this tractor and also how well it is made compare today's tractors, especially the flexible rear end and the rollers.
      Tell the next time 
      · 9 replies
    • jbrooks

      jbrooks  »  Talntedmrgreen

      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
  • Adverts