Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
ka9bxg

wonderboy 700 tiller belts

Recommended Posts

ka9bxg
I need toknow what size belts are used on the tiller I have all the pulleys and equipment but no belts.I do not intend to use simplicity belts.Bob

Share this post


Link to post
Share on other sites
MikeH
I just put mine on this weekend to till the garden. There are 2 tiller belts and if you switch the trans drive pulley on the right side from 6" to 8" then there is a third belt. This switch to the larger pulley makes the tractor go slower and is very helpful. The 8" drive pulley belt is 45" The belt from the tractor to the large pto on the left side is 53" and the belt from the pulley inside the large pto to the tiller itself is supposed to be 42" but I had to use a 45" belt on mine. I can double check the sizes and get you part numbers by looking at my book when I get home. Good luck...Ken Williams

Share this post


Link to post
Share on other sites
MikeH
Here's the first page of belt sizes[A href='http://www.simpletractors.com/parts/belts/belts_(pg_16).htm']http://www.simpletractors.com/parts/belts/belts_(pg_16).htm[/a]

Share this post


Link to post
Share on other sites
KenW
OK, finally found my book, the belt from the tiller itself is 42" Simp part #154273, ( I had to use a 45" belt on mine) from the large pulley, over the idler pulley and to the pto it is 56" long, #105122. My previous post from memory said it was 53" and that was an error. Sorry about that. Good luck and good tilling. Ken Williams

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

×