Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
MPH

PB blaster and Aero Kroil failing

Recommended Posts

MPH
Anybody know of any other majic penetrating oils? so far these two only failed me once. Been trying to get the sleeve assy on my rear pto off the rear lift assy. rod. think its been on there since 1962. Don't want to heat it because of the bearing which spins smooth. thanks for any suggestions MPH

Share this post


Link to post
Share on other sites
geezer
i see you mentioned PB blaster when you sprayed it on did you you rap it with a med ballpeen hammer to break up the rust so the oil can get into the part if not try that and let it sit for sometime then go back and do it again it works for me . i swear by the stuff .(not at it) give it a shot and good luck with it . matt

Share this post


Link to post
Share on other sites
JeffNemes
Have you tried drilling or cutting some new "squirt" holes with a wizzer wheel to allow further penetration? You can weld them back up later if needed. Personally I think Sili-Kroil has a slight edge over the others. You can also try making a container and submerging the assy. in kerosene for a week or two.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

×