Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

PB blaster and Aero Kroil failing


MPH

Recommended Posts

Anybody know of any other majic penetrating oils? so far these two only failed me once. Been trying to get the sleeve assy on my rear pto off the rear lift assy. rod. think its been on there since 1962. Don't want to heat it because of the bearing which spins smooth. thanks for any suggestions MPH
Link to comment
Share on other sites

i see you mentioned PB blaster when you sprayed it on did you you rap it with a med ballpeen hammer to break up the rust so the oil can get into the part if not try that and let it sit for sometime then go back and do it again it works for me . i swear by the stuff .(not at it) give it a shot and good luck with it . matt
Link to comment
Share on other sites

Have you tried drilling or cutting some new "squirt" holes with a wizzer wheel to allow further penetration? You can weld them back up later if needed. Personally I think Sili-Kroil has a slight edge over the others. You can also try making a container and submerging the assy. in kerosene for a week or two.
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...