Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
rpickle

Rear lift arm

Recommended Posts

rpickle
Hi. I just picked up a rear lift arm for my '75 7016h. It was from an earlier B-10 model. Right off the bat I have noticed that the pivot bar is the same size across the full length and where that mounts on the tractor the hole for this arm is MUCH bigger on the left side. Should I bother with trying to make this work or should I try to find the correct arm? They are hard to come by.... I bid one up on e-bay, I finally bowed out at 125 bucks... Would be really nice if I could make this one work. Thanks Rick

Share this post


Link to post
Share on other sites
Simpleton7016
There is a metal bushing/spacer that goes in there and fills the gap so that you can get the arm in and out. Send me a PM b/c I will have some tractor time today and I know I have been tripping over one for a few months now. I don't know exactly where it is, but I know it is somewhere that I will stumble on it again. I can drop it in the mail today. Take that $125 and move the decimal point one spot to the left and you can have it.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

×