Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
Simplicity314

7016 hydro creep

Recommended Posts

Simplicity314
Trying to adjust the linkage on my 7016. I read the procedure in the manual and did a search here and read a few posts on it, but I haven't found anything that describes my problem. When I loosen the bolt near the rod to turn that casting with the lines on it to line it up with the roller, the spring assembly in the rod stops it. If I force it--push against the spring, it just drops back to where it was. Is it possible to slide that assembly up the rod farther? It doesn't look like it since there are 2 roll pins in holes drilled through the rod to keep the washers in place that hold the spring. I haven't tried that second procedure yet, as I'd like to try to get it lined up first if it's possible. Thanks in advance.

Share this post


Link to post
Share on other sites
OrangeMetalGuy


Do the 2nd procedure. It's easy and once you've done it you'll agree. How much is it creeping? I had to do this adjustment on mine.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

×