Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
Brucep

Rear light

Recommended Posts

osenga
I am using them on my 916 and and on three 7100's and have the all wired to the toggle switch and through my key switch and i have not noticed them pulling hard and there the lights that were used on the old 1964 broodmore

Share this post


Link to post
Share on other sites
dentwizz
I use 2 55 watt lights up front and 1 in the back with independent switching front and rear. If your system is up to spec and engine speed is above half you should be fine. That said, I only use the rear when needed and I turn it off as soon as I don't. If you don't mind a little less light, you can find a 35w halogen work light and leave it on with the main set.

Share this post


Link to post
Share on other sites
Cvans
Napa has a very nice light in a rubber housing with the mount for $11.99 and it doesen't draw much. I think it is a 4 1/2" sealed beam and puts out plenty of light. It only has an 18 ga. wire. The other option I have used is the LED driving lights. They are inexspensive and draw almost no power.

Share this post


Link to post
Share on other sites
HubbardRA
The "B" series tractors use the 4411 bulb in the headlights which is a 35 watt bulb. You could use either a 4414 or a 4444 bulb on the rear. Both of those are only 18 watt bulbs.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

×