Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
osenga

7100 rearend Question

Recommended Posts

osenga
I was out plowing my garden today and about half way through it I went up to get gas and saw my rearend was leaking bad fluid out . I had a back up and i put that on the switch over is a pain in the rear . forward and reverse both work good fluid is ok in rearend . But my hydro lift is not working so the question is on the lever you push down to push it in netural in them valves is there to be fluid in them and if so what do I want to put in it . Thanks for input

Share this post


Link to post
Share on other sites
HubbardRA
If the transmission that you just installed was from a tractor with a manual or electric lift, it doesn't have the correct bypass valves to power the hydrolift. Swap the check valves from the one you replaced into the holes shown below to provide the correct pressures for the hydrolift. You probably only have about 250 psi going to the hydrolift when you should have around 750 psi for good lifting capabilities.


Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

×