Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

7100 rearend Question


osenga

Recommended Posts

I was out plowing my garden today and about half way through it I went up to get gas and saw my rearend was leaking bad fluid out . I had a back up and i put that on the switch over is a pain in the rear . forward and reverse both work good fluid is ok in rearend . But my hydro lift is not working so the question is on the lever you push down to push it in netural in them valves is there to be fluid in them and if so what do I want to put in it . Thanks for input
Link to comment
Share on other sites

If the transmission that you just installed was from a tractor with a manual or electric lift, it doesn't have the correct bypass valves to power the hydrolift. Swap the check valves from the one you replaced into the holes shown below to provide the correct pressures for the hydrolift. You probably only have about 250 psi going to the hydrolift when you should have around 750 psi for good lifting capabilities.


Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...