problems with pto

[Bunky]

I have a B112 and the pto for the mower is not right when you turn off the pto the idler drops down on to the bottom pulley and when you go to turn it on you have to lift the idler up to get it to engage does anyone have a breakdown or can help?

[Sandy_Lake_Imp]

There is a short flat strap mounted on the same bolt as the idler. The strap has a small hooked edge on the end which should contact the end of the sliding rod & keep it from flopping past center. Bill

[Kent]

Bunky, Sounds like it's well-worn. You may be able to adjust this out. Try adjusting the engagement rod to where the pulley is slightly over-center when disengaged, so it doesn't fall down too far... It may take a couple of adjustment tries, but I've had to do this on my B-210 also... Kent