Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
TomSchmit

Guide light

Recommended Posts

TomSchmit
Here is an original rear work lamp off a B-10 with the original mount. It is in good enough shape that it could be restored. Is it possible to get replacement bulbs (sealed beam lamps) that fit in this housing? Thanks - Tom




Share this post


Link to post
Share on other sites
sammiefish
this is a good chart that might help as well... the 3/400 uses the 4411's The number is likely still visible on the lamp. http://www.simpletractors.com/club2/topic.asp?TOPIC_ID=42974

Share this post


Link to post
Share on other sites
TomSchmit
Thanks for your prompt help, guys! There is a hole in the housing that is clearly sized for a switch, and a second small hole where a grounding wire was attached. Did the original rear work lamp have a switch on it? Is the ground screw hole original or did PO drill a new hole? Tom

Share this post


Link to post
Share on other sites
TomSchmit
Storm - The bracked is 1-1/4 onch wide and about 6" long if not bent. The bend (as you see in the pictures above) makes a 45 degree angle. The steel is 3/16". That is about the best info I can give to you. Tom

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

×