Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Guide light


TomSchmit

Recommended Posts

Here is an original rear work lamp off a B-10 with the original mount. It is in good enough shape that it could be restored. Is it possible to get replacement bulbs (sealed beam lamps) that fit in this housing? Thanks - Tom




Link to comment
Share on other sites

this is a good chart that might help as well... the 3/400 uses the 4411's The number is likely still visible on the lamp. http://www.simpletractors.com/club2/topic.asp?TOPIC_ID=42974
Link to comment
Share on other sites

Thanks for your prompt help, guys! There is a hole in the housing that is clearly sized for a switch, and a second small hole where a grounding wire was attached. Did the original rear work lamp have a switch on it? Is the ground screw hole original or did PO drill a new hole? Tom
Link to comment
Share on other sites

Storm - The bracked is 1-1/4 onch wide and about 6" long if not bent. The bend (as you see in the pictures above) makes a 45 degree angle. The steel is 3/16". That is about the best info I can give to you. Tom
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...