Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  

312 H Axle tube job parts ordered

Recommended Posts

Well, I hope Im getting all I need.... Yesterday I ordered: 1 TUBE BUSHINGS ASMY part # SM1670864 $128.37 2 KEY PARALLEL PLN 25 part # SM2154096 $1.37 1 GASKET GEAR CASE 0 0 part # SM2166043 $4.74 1 FITTING LUBE 250 28 part # SM2812808 $1.23 1 SEAL OIL 2 500ID X 0 part # SM2121190 $4.08 If anyone can suggest some thing I forgot for this job I would appreciate it... wish me luck thanks chris

Share this post

Link to post
Share on other sites
I'd get some gasket sealer too.... you want to put some on the case half, set the gasket on it, then put more sealer on the other side before putting the case halves together. Also, if your has a filter (I don't know much about Vickers) you might as well change it while you're at it.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

  • Who's Online (See full list)

    There are no registered users currently online

  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
      · 1 reply
  • Adverts