Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

DMedal

Onan part number for starter?

Recommended Posts

DMedal
Does someone have an Onan parts manual to look up a part number for me? The Onan engine is model # CCKB.MS / 2440H serial 174743082. It is on a Simplicity 4041. The part number I need is the starter. Was there more than one starter type for the CCKB? My new one sounds terrible, I'm trying to verify I got the right one, but that probably means pulling it again. It fit, I didn't compare the gears or anything. Don

Share this post


Link to post
Share on other sites
StanD
There was 3 starters for the cckb. It lists 2 for your model, 191-0734 & 191-0922. Latest # for Spec J is 191-1052. I believe even the lastest # has been superseeded. Sounds like you may have mesh to tight on drive to flywheel. There is enough room in the holes to make them too loose or too tight. I usually spin them over before I reinstall the engine to avoid having to do it over.

Share this post


Link to post
Share on other sites
midnightpumpkin
Not an expert on the CCKB's, but I believe there are shims involved in mounting the starter. DMedal, send me an e-mail and I will send you the Parts list for the CCKB. John U

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Who's Online (See full list)

    • Homiet16
  • Today's Birthdays

    1. Trevor Hostetter
      Trevor Hostetter
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts

×