Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
jmcj10

swapping a shuttle for a 3 speed in a7016

Recommended Posts

HubbardRA
Easiest way is to remove the shuttle rear and replace it with a 3-speed rear. Then you remove the shuttle lever. Reverse will end up where 4th is on the shuttle. Supposedly the shuttle tranny can be taken apart and 4th gear can be replaced with reverse. If this is done, then the external shuttle planetary needs to be replaced with a fixed pulley. Hope this helps you at least a little.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

  • Who's Online (See full list)

    • jackcobb
    • simplewrench
    • Scott Salmons
    • Tom45
  • Today's Birthdays

    1. Jcarlton300@gmail.com
      Jcarlton300@gmail.com
      (30 years old)
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×