Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
Simplicity_728

Dipstick Question

Recommended Posts

Simplicity_728
I put a dipstick on my 728 engine off an 8hp Briggs out of a sears garden tractor. I like it alot better then just having the fill plug. The problem is the dipstick will screw in tight all the way but if turned any more it will pop up. It runs fine and it doesnt smoke or use oil with it like this. So I assume im not losing crankcase pressue. Is it alright to run the engine with it like this or should take it off and use the plug?

Share this post


Link to post
Share on other sites
Simplicity314
One of the first things I do is lose that tube. Even if those threads snugged up, you would still have seepage, and if you used teflon tape or something to make a tight seal, it would still seep between the tube and where the tube is pressed into the threaded piece (they are 2 pieces). You will have a big oil/grime spot around the tube. With the plug, you can tighten those down really tight with the two little posts where you can use a screwdriver for leverage.

Share this post


Link to post
Share on other sites
Simplicity314
quote:
Originally posted by bud119195
I use the plug. I think its easier to pull the plug and top it off than get correct amount on dipstick
Another good point--it's impossible to overfill them with the plug. Just fill to the threads and good to go.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

  • Who's Online (See full list)

    • s_stephen
    • wwbragg
  • Today's Birthdays

    1. r32ford
      r32ford
      (81 years old)
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×