Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
mroman59

discovered oil leak on 7117 - help

Recommended Posts

mroman59
As I was repairing my clutch cone assembly and BGB I noticed oil dripping on to the garage floor. I cant seem to find where it is coming from. There is oil collecting on the transmission case, left side of tractor, at the point where a bolt attaches the transmission to the side plate at the bottom. That bolt is just above and in line with the left side axle. The oil appears to be on the inside of the side plate and collecting on the part where the bolt threads in. Has anyone had a similar leak in that area? thanks, MR

Share this post


Link to post
Share on other sites
Vassal
I think (out loud) we were just talking about your repair to the hyd hose fitting right? Is it possible this is fluid that dripped down when charge pump was removed and only now it has made it's way down to drip on the floor? That's the same side as this new(?)leak right?

Share this post


Link to post
Share on other sites
mroman59
yes it is the same side as the charge pump, however I thought about that possibility and I looked around the housing and lines and they are all dry. I am thinking that the leak was probably already there because I checked my shed which has a wood floor and there is oil where the tractor sets. Less obvious than in the garage.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

  • Who's Online (See full list)

    • smalljob
    • goatfarmer
    • MARK (LI)
    • Ronald Hribar
    • rich_kildow
    • MRR
  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×