Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Boney

Choke help please

Recommended Posts

Boney
19D motor {i believe} when starting from cold I put on full choke, then after it warms up about 5 minutes start closing the choke. No matter how warm the engine gets I can not close the choke all the way. If I do it will stall out. I have plenty of gas in the tank and the fuel filter is clean. Any suggestions as to what I can do to get the carb running properly ? Thnx for any help

Share this post


Link to post
Share on other sites
MrSteele
What was said above. Add checking the tank filler cap to be certain it is breathing or vented. You might have to remove and clean the main jet, or simply remove and clean the carburetor. But, it sounds as if a simple adjustment might do the trick.

Share this post


Link to post
Share on other sites
dentwizz
Check idle speed also. Some of those old ones don't idle all that slow(unless "enhanced:D" The adjustments of the idle mix/main mix and idle speed are a balance act which starts with idle mix once warm.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Who's Online (See full list)

    • smalljob
    • dhoadley
    • SmilinSam
  • Today's Birthdays

    1. r32ford
      r32ford
      (81 years old)
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×