Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
Followers 0
osenga

regulator

By osenga, in Talking Tractors

Recommended Posts

osenga    0

osenga
Posted
I was out putting the 725 last few peices back on it and have to mount the regulator box and when i grabbed it my finger wer on the bottom of it and the battery is hooked up and my one finger touched one of the springs on the bottom of it and the one was pretty warm to the touch would not want to keep hand on it long and i have it so the toggle switch is no power going to the points. is this right or do I have something wiried up to it wrong but i know it runs so not got a clue now

Share this post

Link to post
Share on other sites

osenga    0

osenga
Posted
well I have that problem figured out it was because I had a brain fart when hooking up wire turned the Batt. and the Gen to the wrong post . And I have had it running at idle speed and tonight when i gave it half to full throttle it sputters and dont matter where I set the carb at . The head gasket does have a leak . could this be my problem or any other ideas out there

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  
Followers 0
Go To Topic Listing Talking Tractors

  • Who's Online (See full list)

    • NateShedivy
    • Chris727

  • Today's Birthdays

    No users celebrating today

  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply

  • Adverts

×