Bull_79 0 Posted August 8, 2010 While I have the motor out of 1964 LL what would you recommend I do as far as tuneup? The coil looks pretty bad but it still works and with all that mouse nest being in there rusted it up pretty good. Thanks and if you didn't already check out my build thread in Show and Tell. Share this post Link to post Share on other sites
dirtmister16 0 Posted August 8, 2010 well, long as it is out. you could pull the head and clean it, check points, maybe replace as preventive maintence. maybe pull the carb. bowl look see if it looks grungy, if it is perhaps a cleaning is in order. could just rebuild it, lol. it is out of the tractor. haha. give a general check over is what i would do. if you want to and have the time take it down to the block and clean it and repaint. make it look good is always nice, and easier to work on. Share this post Link to post Share on other sites
Bull_79 0 Posted August 8, 2010 Yeah have done all those things already,so sounds like I am off to a good start. Share this post Link to post Share on other sites
Al 6 Posted August 8, 2010 Hi, I would check the "play" in the bevel gear box front shaft and the seal for leaks. Al Eden Share this post Link to post Share on other sites
dirtmister16 0 Posted August 9, 2010 ^^^^^good point AL, i had addressed his motor questions, did not think to go to the next logical step on the tractor. that is why you take a second opinion on things. something else on the tractor that could be checked over while the motor is out and makes things eaiser. check your front axle if you have any play go ahead and address what you can, it the front bushing is wore, find new bolt, and bushing replace. Perhaps your have steering gear or linkage issue, check and see how things look. I forget how easy it is to check the gears with the dash tower in, but seems to me its not terrible. Share this post Link to post Share on other sites
Bull_79 0 Posted August 9, 2010 Ok thanks all good stuff,I will check all of these that's why I ask these questions because you guys have all been there done that. Share this post Link to post Share on other sites
dirtmister16 0 Posted August 10, 2010 no problem, its a community thing, were here to help. heck i dont' know nothing compared to most of the guys on here. im still a learning these old things. Share this post Link to post Share on other sites