Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
snohiker

blowing oil

Recommended Posts

snohiker
hey guys i have a 3410 ive been playing with for the couple weeks ive got it to run still a little touchy needs a carb cant get this one apart tube is stuck and to corroded anyways its got alot of crank case pressure every so often it starts to blow oil out of the breather i had a go cart as a kid that did this but the carb we had on it was way over sized so it had two speeds fast and border line blowing up but the 3410 runs nice and slow any ideas am i missing something

Share this post


Link to post
Share on other sites
AC_HB-112
Carb problem. soak it in PB'Blaster every hour or so for four hours, try to get it apart again if dosn't work, soak it once more, let it set over night. Apply heat and it should give.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

  • Who's Online (See full list)

    • MARK (LI)
    • joelk
    • NandoG
    • HotRod2
    • PhanDad
    • Tom45
    • rich_kildow
    • Bear
  • Today's Birthdays

    1. r32ford
      r32ford
      (81 years old)
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×