Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
ikipp

Sunstar oil cooler cleaning = help

Recommended Posts

ikipp
Well my sunstar has started to overheat. Tried to clean out big round cooler, right behind the engine, in front of the battery. I can not get at it to blow out the fins without taking half the tractor apart. Is there a trick to blowing out the coolimg fins. Thank you. P.S. Also looking for a 60" mowing deck for my sunstar.

Share this post


Link to post
Share on other sites
comet66
Where the driveshaft enters the fan housing there is a removable plate that allows access for service of the front u-joint. If you remove that you can blow air from the bottom up. This works pretty well as the normal airflow through the trans cooler is from the top down. If you're running a Kohler, those engine shrouds get plugged up pretty fast and solid. You may want to check that as well.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

  • Who's Online (See full list)

    • spi
    • a_sannine
    • rbstuartjr
    • rich_kildow
  • Today's Birthdays

    1. Jcarlton300@gmail.com
      Jcarlton300@gmail.com
      (30 years old)
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×