Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors


Need Help With 1964LL

Recommended Posts

On my 1974 10hp briggs, there is a spring on the vertical linkage in that picture - it actually slips over it, and connects pretty much to each end. I don't know if the 64 vintage have a similar spring.

Share this post

Link to post
Share on other sites
Do you have a rod with it? When I got mine it was missing. I took a stainless steel bike spoke(happen to have a bunch) and formed a hook to install in the carb end. Push upward on it to close the throttle plate and make sure your gov arm is also up on stops. Form the hook to match and voila it should work. Never had any trouble with it since. I'll see if I can get some pix tomorrow, but the gist of it is those two positions lining up.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Who's Online (See full list)

    • tripleguy
    • BLT
    • RickS
    • ryanoffroad
    • PhanDad
    • ShaunE
    • GregB
  • Today's Birthdays

    1. glolive
      (71 years old)
    2. lampoulos
      (41 years old)
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
      · 1 reply
  • Adverts