Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

  • Announcements

    • Kent

      Sign In or Password Problems?   10/09/2016

      If you can't Sign In, you need to reset your password.  Use the Forgot Your Password link at the bottom of the Sign In screen, and the site will send you an email to reset it. If you have an AOL email account, use the Contact Us link at the bottom of the screen -- AOL is intermittently blocking email from the site.
    • Kent

      Feedback Please!   10/28/2017

      See News and Announcements forum.
Sign in to follow this  

plow hook up parts

Recommended Posts

A- 1/4 inch B- 7/16 inch hole C- 13/16 end to center of hole D- 4 inches E- 2 inches F- 2 inches G- 1 inch pipe H- 13/16 ID I- 1/2 inch below bottom of hitch to flush with the bottom. i have several hitches and all are somewhat different. overall length of "G" should be 4 inches J- 3/8 K- 11/16 hole L-1 1/4 inches M- 5 1/4 inches N- 2 1/2 inches O- 3/8 inches P- 4 inches Q- 1 inch R- 1 3/4 inches S- 5/8 inches T- 3 inches U- 3/4 inches V- 1 1/8 inches W- 3/8 inches X- Irrelavent. whatever is left after locating "V" Y- Change "Y" to indicate inside measurement, not outside. should be 4 1/8 inches. do not make this a tight fit! depending on what you have available to use for material, most of these measurements can be fudged. most of my hitches have an additional brace running across the hitch (2o3). if you put one in, make sure your hitch will slide into the bottom of the rear lift where it gets pinned and move freely before you weld. (sucks to have to cut it free and reweld it) good luck

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this