allisman Posted May 9, 2011 Posted May 9, 2011 I have a 912 that I can't get to cut any higher than 2 1/2". I have the front mounts at the highest possible position and the two adusters on the rear as high as they will go. Would like to get it to cut at 3". What I'm I doing wrong?
wilm169 Posted May 9, 2011 Posted May 9, 2011 This has been covered many time before, if you can do a search you shoud come up with your answer. WELCOME to the club; http://www.simpletractors.com/club2/search.asp?sectionid=4
Burntime Posted May 9, 2011 Posted May 9, 2011 Search and rebuild the rollers and bar. You will get 3 1/8 asuming you are not using gull wing blades...
Recommended Posts