ka9bxg Posted May 20, 2011 Posted May 20, 2011 I just put the mower on the allis the other day. The belt that drives the mower is rubbing on the spacer bar, It has a new v pulley idler on it. Does anybody know what size pulley is suppose to be on there.the pulley was in the box of parts when I got it. The mower was completely apart when I got it. Also the adjuster bars rub on the tractor (wore off the paint on them) I am sure everything is put together correct.Any ideas Bob
dhardin Posted May 22, 2011 Posted May 22, 2011 From your description I'm not clear on your exact problem. The mower pulley is a cast iron special pulley. The only idler I know of is on the belt that is inside the deck that goes to each blade, I thinking its a 4" pulley. I have just went completely over my 4041 deck and there was belt marks on the top of my deck from its past. Since I reworked the spindles and all the pins and joints they all had some wear/slop the deck is riding much better. The bottom rollers and axle need a lot of attention. The mounting pins aloud the deck to sag and was imposable to raise very high and blade alignment. A pic would really help. Good luck Dan H
gregnorth Posted June 7, 2011 Posted June 7, 2011 sounds like the spacer bar could be on upside down.
ka9bxg Posted June 7, 2011 Author Posted June 7, 2011 You got it right.The bracket was upside down I got a P,M. a while ago and that did fix it.Thanks for the reply. Bob
Recommended Posts