MadMike Posted May 27, 2011 Posted May 27, 2011 I have a strange situation that I hope someone has experience with. On my 7119H, the throttle will not stay at full without physically holding it there. I can push the throttle to full and watch the handle slowly drop back to about half. This just started happening within the last week or so. Any Ideas? Mike Z.
osenga Posted May 27, 2011 Posted May 27, 2011 you can try to tighten it up or add another nylon washer in there
Tom45 Posted May 27, 2011 Posted May 27, 2011 You will probably have to remove the steering wheel and lift up the panel below it which is held on by 4 screws (be careful with the ammeter wires, but you probably can just lay the panel to the side.) Inside, the throttle has a nut against a spring washer and a pair of plastic washers. Tom
MadMike Posted May 27, 2011 Author Posted May 27, 2011 Thanks for the advice, I'll be getting in there tomorrow.
Recommended Posts