CVSB10JCS Posted June 2, 2011 Posted June 2, 2011 The big pully thats hangs underneath and runs the deck is getting hot and the front smaller pully squeels when I spin it by hand. So I need both of them but my question is the bracket itself seems like the holes are egg-shaped. Are there any measurements anyone has so I can get it back in position and get the holes built back up? Like center of shaft should be so far down/back from center of such and such bolt??/
rm Posted June 2, 2011 Posted June 2, 2011 there are oillite bearings that belong in there there should be a grease fitting too
Recommended Posts