Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  

PTO Pulleys

Recommended Posts

As I get the 3212 up to working order, I need some pulleys. The 1st pulley will be for the mid PTO. The previous owner seems to have kept the pulley. From looking at the manual, the top pulley is Part #2157121 (5.00 OD .876 ID .5 Groove). As I am unfamilar with pulleys, and the cost of the OEM, I found this one... http://www.phoenix-mfg.com/acatalog/Fixed_Bore_Type_Cast_Iron_Drive_Pulleys.html (See 5" OD Pulley) For the front PTO for the snowblower is Part 2156111 (04.500 OD 1.001 ID 0.630 groove). http://www.phoenix-mfg.com/acatalog/Heavy_Duty_Drive_Pulleys_A_B_Type.html (See 4.5" OD Pulley) Will both of these work?

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

  • Who's Online (See full list)

    • a_sannine
    • MARK (LI)
    • BenB
    • gwiseman
  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
      · 1 reply
  • Adverts