Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

gjh

How to check ignintion system

Recommended Posts

gjh
My B&S 12hp on my '73 Homelite has no spark. Checked pts/condensor and gap, all seem fine. I replaced them last year and it has been running fine till a month ago. Replaced ign switch today as it has been acting up for awhile, still no luck. How do I go about trouble shooting the system? I have a meter; but my electrical knowledge is limited. Thanks: Gary Hamilton

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Who's Online (See full list)

    • MARK (LI)
    • TTDE419
    • midnightpumpkin
    • Rido58
  • Today's Birthdays

    1. sandyhillbill
      sandyhillbill
      (81 years old)
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×