Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
NandoG

Moving 4 tons of gravel with My 7116H

Recommended Posts

NandoG
Hi all, I am planning on getting a shed and I have to make a base for it with gravel. The gravel was delivered last Saturday and I finely had some time today to finish moving the 4 tons of gravel, the shed will be delivered next week. Here are some pictures.
[img]/club2/attach/NandoG/DSC06189 legacy.jpg[/img]
Last load
[img]/club2/attach/NandoG/DSC06193 legacy a.jpg[/img]

[img]/club2/attach/NandoG/DSC06197 shed.jpg[/img]

Share this post


Link to post
Share on other sites
IronPony
This past spring I put crushed rock in 6 carports that I have here at my fishing resort. Each one took a full ton of rock. Did it in one day using my pick-up truck and a Load Handler. I tailgate spread each carport and it was easy. My half ton Chevy handled the full ton loads with ease!

Share this post


Link to post
Share on other sites
Sign in to follow this  

  • Who's Online (See full list)

    • smalljob
    • bowhunt4life
    • Cityboy
    • Bill725
    • AC710
    • jkysh
    • BruceH
  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×