Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
tripleguy

Pulley reomval from snow blower

Recommended Posts

tripleguy
I have a 42" blower for a 7100 series tractor that came with a front PTO hitch. I've since replaced that hitch with a mid-PTO and I've noticed the drive pulley on the blower is mounted with the collar facing left with the front-mount hitch and it needs to be reversed for the mid-PTO hitch. This is to position the drive pully slightly left of center for the mid-PTO drive. My pulley is frozen on there. I have the set screw out and I can see the key is centered but I'm stuck. There really isn't a lot of room to hit it with a mallet or block of wood either has the blower housing doesn't give me much room. Any suggestions for getting it off? Would heating the pulley help? Thanks!

Share this post


Link to post
Share on other sites
tripleguy
Thanks guys - got it. Took some penetrating oil, heat and force (beat it loose with a 3 lb hammer - carefully if there is such a thing with a 3 lb hammer). Cleaned it up, put it on backwards, with the collar facing out and it got me aligned where I need to be. I also had to bend the belt keeper but from what I can tell, those are the only differences in a front PTO and mid-PTO mount. I should be ready well before the first flakes hit the ground. Now, I've got to see if my chains and wheel weights fit.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

  • Who's Online (See full list)

    • GregB
    • Zoomie91
    • jlasater
    • rokon2813
    • TTDE419
    • Drhulv
    • simplewrench
    • BAP
    • AC710
    • Gaucho
  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×