Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
sierradriver

Big Ten Fluid

Recommended Posts

GLPointon
Yes, thats how I do it... fill from top plug on R.side of trans until its up to level of Fill Plug (on R.side about 1/4 way up from bottom)(some have a 45-street ell with a plug) Same w/BGB; fill from "vent plug" on top till its up to level of Fill Plug (on back of BGB 1/4 way up from bottom)

Share this post


Link to post
Share on other sites
MikethePlumber
Andy, Are you filling it with SAE 90 as per manufacturers instructions? If so, where did you find straight 90 weight? I went to a few local auto parts store here in southern New Hampshire and no one seems to carry straight 90 weight oil. -Mike

Share this post


Link to post
Share on other sites
GLPointon
I think your better off using the "multi-viscosity" gear lube like 80w90(I use synthetics)..Its a bit thinner/better in cold weather. For jobs like snowblowing, etc... I've even seen 75w140, but the bigger the visc. swing the more additives needed..... 2cworth

Share this post


Link to post
Share on other sites
jasper
I think I read that the later models took Simplicity Multi fluid. I also believe that is type f or atf. I spoke to the local dealer here and he thought that any good grade of oil would work. I am running sae 30 in two that I just rebuilt and have had no trouble. The late model and early one are the same inside. With that said I am running 75-90 in my 7116 for a couple of years with out trouble also.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

  • Who's Online (See full list)

    • smalljob
    • GregB
    • gwiseman
    • rokon2813
    • tadams
    • jkysh
  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×