Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
wilm169

What A Pain

Recommended Posts

wilm169
Been looking for rivets for my sickle bar on the power max, Parts book said it was a #5 1/2 rivet. Well no one knows what that is any more. The Bad part of it is the are 7/32s x 5/8, and no one stocks them just 3/16 or 1/4. Persistence wins out I found them here :D; http://www.sickleservice.com/page/140/ Now to see when they get here.

Share this post


Link to post
Share on other sites
Talntedmrgreen
Same source used for B series sicklebar knives and rivets. I'll have to look through my notes for which P/N those were. Do the larger, Pmax sickles use the same size knives?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

  • Who's Online (See full list)

    • jdmillman
    • smalljob
    • SmilinSam
    • GregB
    • Zoomie91
    • jlasater
    • rokon2813
  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×