Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
bowhunt4life

Flywheel Pulley

Recommended Posts

bowhunt4life
Will a Flywheel Pulley from a 16hp Briggs work on a 10hp Briggs? I stripped the threads pretty good yesterday and found a pulley on fleabay. Appearance is similiar but am not sure if the flywheel pulley would be interchangable?

Share this post


Link to post
Share on other sites
RayS
If the numbers are the same they will fit. Any 16hp pulley were the same from a magneto to a magentron engine that I ever seen. The picture you have in the classifieds for your 10hp is the same as the 16hp. 10hp http://bsintek.basco.com/BriggsDocumentDisplay/default.aspx?filename=18mqvGXAnfBhU7y 16hp http://bsintek.basco.com/BriggsDocumentDisplay/default.aspx?filename=18nnALXAnfBhU7y


Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

  • Who's Online (See full list)

    There are no registered users currently online

  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×