Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
merlinct7

Ammeter Retention Ring

Recommended Posts

DanD
It probably isn't available as a separate part. Usually just comes with a new ammeter. Best place to look would be at a junkyard. This is a pretty standard piece that would be on the ammeter of pretty much any tractor(including other garden tractors or old farm tractors). Older ones were made of metal with plastic rings insulating the holes. Otherwise try to glue yours with some superglue and tighten gently!

Share this post


Link to post
Share on other sites
ReedS
That looks like it will outlast any new plastic piece that you could buy new! As long as the ammeter studs remain isolated from the chassis all is good. I have a couple of those off one of my fdt's next time your here or I'm there!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

  • Who's Online (See full list)

    • PhanDad
    • tadams
    • SmilinSam
    • rgrabinger
  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×