Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  

Wrong Time of Year But Need Info on a Tiller Hooku

Recommended Posts

I am getting ready for Spring 2012 real early--- could someone post some photos of the belt hookup from the PTO for a tiller attached to an AC Big 10 garden tractor?? I believe some parts on mine are missing. Thanks!!!

Share this post

Link to post
Share on other sites
There is a single belt that runs from the BGB pulley, around that is a bracket that mounts to the side of the frame. That belt runs back to the mule drive assembly. The mule drive slides on the shaft that is on the drivers side of the rear lift assembly. There is a piece of the mule drive that pins at the bottom rear lift on the drivers side of the assembly. From the mule drive there is a second pulley and belt that runs to the tiller. That's pretty much it. If you PM me I can send you the user's manual.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

  • Who's Online (See full list)

    • Brettw
  • Today's Birthdays

    1. B10Dave
      (69 years old)
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
      · 1 reply
  • Adverts