Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
B10Dave

Clutch/brake rod

Recommended Posts

B10Dave
:O PO bent up a clutch/brake rod from 5/16 material for my B1. He tried to thread it without much success. I replaced 5 in. of the end with ready rod today. Works fine now after adjusting by the book. Dave.








Share this post


Link to post
Share on other sites
Sign in to follow this  

  • Who's Online (See full list)

    • Bird76Mojo
    • SmilinSam
    • gwiseman
    • NandoG
    • smalljob
    • Bweb
    • Bear
    • NateShedivy
    • simplewrench
  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×