Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
rokon2813

Any Idea's ??

Recommended Posts

rokon2813
Looks like a hi lo to me, but narrower, totally different looking cover, came off a 3 speed B series tranny unfortunately it is set up, so I can't see what it is supposed to do Any thoughts ????




Share this post


Link to post
Share on other sites
B10Dave
Dan; while it was on the trans input shaft did you try to rotate the pulley and see if the shaft rotated with a 1 to 1 ratio. Maybe it is a non shiftable slow speed planetary set for a permanent slower speed? Just a thought. Dave. OOPS, just reread your post where you say it is seized. Guess you can't rotate the pulley by itself.:O

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

  • Who's Online (See full list)

    • PhanDad
    • Evanm
    • SmilinSam
    • smalljob
    • Bill725
    • RickS
    • MARK (LI)
    • NateShedivy
  • Today's Birthdays

    1. sandyhillbill
      sandyhillbill
      (81 years old)
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×