Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
osenga

B/S model 19 leg

Recommended Posts

osenga
I got the leg for my coil today. Thanks Dan. I wont say how I got the leg out of the old coil and into the new one . I would like some ideas. On how you guys get yours out and the the leg through the new one . It is such a tight fit putting it back in the new one . I know a few of us have done it here. but once it got it all set back up somewhat for a test fire up to check spark and if it would run and all. the other 19s i have dont have no spark like this one at all. This replacement was well worth the money spent it is a hot spark and really blue and not faint like my other 2 I have out there. They will be reaplaced here to 1st of the year after seeing this . But any suggestions of how to get the leg out and back in would be great

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

  • Who's Online (See full list)

    • GregB
    • Koabd1978
    • Bear
    • BLT
  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×