Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

PhanDad

Drive Shaft Reference

Recommended Posts

PhanDad
I just added a Drive Shaft Reference post in Tech Tips & Articles: http://www.simpletractors.com/club2/topic.asp?TOPIC_ID=119807 Please add other info to it.

Share this post


Link to post
Share on other sites
larry8200
quote:
Originally posted by Brettw
Good post. Thanks, Bill I think the K301 and 321 were the same as the Briggs 16
I am going to replace (One day) the K301S in my 7112H with a Briggs 16 and it looks like the Briggs will bolt right up. Here are pictures of the shaft on my 3416H and 7112H. The only problem is the 7112H frame has a cutout for an oil drain on the right (unused) The K301 has the plug on the bottom




Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Who's Online (See full list)

    • 608ronh
    • goatfarmer
    • BruceH
    • phillobbezoo
    • PhanDad
    • Sw1966
    • gwiseman
    • joelk
  • Today's Birthdays

    1. r32ford
      r32ford
      (81 years old)
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×