Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
osenga

7112

Recommended Posts

osenga
Got back out in shop now and went to try now it's dead no power at all so now I'm lost time to start all over think Murphy is here who want him can have him Ray oil checks out fine Josh I think the whiteish smoke is from gas but un sure yet Just think now it won't run does to its dead now maybe a wiring problem and coil not staying hot at all times like the kohler needs to be grrr

Share this post


Link to post
Share on other sites
osenga
Well The motor is on the bench. Found the head gasket is needing replaced. and now a new carb seal no biggie. Just hope this takes care of the problems. But it will be a good spare back up motor. and the rest of it is going to hit the eBay

Share this post


Link to post
Share on other sites
MDB
quote:
Originally posted by osenga
Well The motor is on the bench. Found the head gasket is needing replaced. and now a new carb seal no biggie. Just hope this takes care of the problems. But it will be a good spare back up motor. and the rest of it is going to hit the eBay
Or the other option since you have the motor out would be to drop a BRIGGS in there......:Dsm06

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

  • Who's Online (See full list)

    • BLT
    • red93
    • Koabd1978
  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×