Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
ken728

Big Ten Experts

Recommended Posts

ken728
Was the Big Ten made through 1966? The engine is correct, but the date code is 660217. I'm hoping this is the original engine - maybe just a later production model? I noticed that the voltage regulator is the same as found on the Landlord 990350, but different than a picture in a brochure from A/C. No complaints here, I plan on adding lights. You can tell if you look close in this picture that there was a light switch wired in at some point but no factory light bar or lights. I'm just in the process of getting geared up to go through this tractor and see what it will take to get it running after sitting for almost 10 years. Thanks.


Share this post


Link to post
Share on other sites
Talntedmrgreen
Looks like overspray around the engine, which would have been yellow for the Big Ten. I'm sure it's possible they sent some out with an early '66 Briggs (Feb 17). Not sure...might have to look for more clues.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

  • Who's Online (See full list)

    • Bill725
    • BAinPA
    • PhanDad
    • maxwood
    • MadMike
    • jlasater
    • dav-1
    • Drhulv
  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×