Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
bigten65

big ten loader

Recommended Posts

bigten65
I am looking at buying a Kwik way loader for my bigten. It is used and don't know what tractor it came off of.What would it take to mount this on my bigten. Do I have make brackets, if so photos would be very helpful and how to mount on the tractor. Do I have to widen the rear wheels, I am going to use it mainly to move snow away from the front of the house. May I drive your tractor, please!

Share this post


Link to post
Share on other sites
RedbarnRick
Here's an article from Simpletractors do it yourself section outlining what it takes to add a loader to a B series, I hope this helps explain it. http://www.simpletractors.com/do_it/b-series_loader.htm

Share this post


Link to post
Share on other sites
comet66
I find moving snow with a loader to be a slow tedious process. Move in pick up a load, not much in a loader bucket, drive over to where it is to be dumped, repeat. Unless of course you are moving a lot of crusty stuff, chunks of ice, etc. I use my blower to clear up close to buildings. The ability to turn the chute in just about any direction makes it pretty fast and easy to remove snow from up close to buildings and vehicles.


Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

  • Who's Online (See full list)

    • Brettw
    • BAP
  • Today's Birthdays

    1. B10Dave
      B10Dave
      (69 years old)
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×