Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
steveo358

Well, I got her running

Recommended Posts

steveo358
Well After going through the carb, person that had it before left bowl gasket off, and some tinkering got the 7018 running. The k-361 seems to be very strong. Only problem is that it is misting,(or spitting) gas out of the carb. Any suggestions to help me get this problem straightened out. My mind is telling me it may need a valve job. Any helpp would be greatly appreciated. Thanks , Steve

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

  • Who's Online (See full list)

    • PhanDad
    • CarlH
    • LumberMatt
    • gwiseman
    • goatfarmer
    • tripleguy
  • Today's Birthdays

    1. BigNickNY
      BigNickNY
      (26 years old)
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×