Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
tobski

plastigage crank

Recommended Posts

tobski
If I plastigauge gap between crankshaft pin and connecting rod (with the correct torque of course), anyone know what that should be for a briggs 243431 engine? not trying to be repetitive in posts just forgot to ask in the previos one. all briggs manual says is rod should be able to move slightly. trying to figure out if my current rod and crank setup will work or if more parts are needed to be bought since engine is opened up. Thanks Tobin

Share this post


Link to post
Share on other sites
robob
If your usesing the green sealed power plastic gauge .001 to .0015 would be about as good as you can get however .002 to .003 would probably be acceptable but no more clearance then that.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

×