Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  

Update on my B-210 still need help with var.spd.dr

Recommended Posts

I took apart my variable speed drive today, ( not too bad to do ) checked out everything and cleaned up a few things. When apart it appears that everything wants to work. Put it back together and started engine while rear end was off ground on jack. I was not able to get the variable speed shifter to shift. When transmission is in gear I got a occasional squeal. My guess is bearing is going on rear pulley, the one off the tranny fork and when put in gear causes occasional squealing ? Spun free when apart ? ideas ?

Share this post

Link to post
Share on other sites
Al, Have you tried the vari-drive adjustment instructions in the service section of Simple trACtors?They seem a bit complicated at first,but they work if you follow them step by step.

Share this post

Link to post
Share on other sites
try following the adjustments to the "T"..I had all sorts of little quiks with mine on a vary worn B112, like clutch worked only in hi or low or somewhere inbetween til I spend the time to adj it all presice thanks to advise off this site. the squeal might be your clutch engagement pulley since it seems you only get it while under load. I got a needle from local clinic and inject these ole sealed bearing with Pro-long, figuring the grease is 40 years old. heck, I was startin to get a little stiff at 40..good luck...MPH

Share this post

Link to post
Share on other sites
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • Chris727
    • dextyr
    • Jjsmachines
    • lt-scir
    • Brettw
    • Bill725
    • Brian Shires
    • msjfc
  • Today's Birthdays

    1. mjbarbero
      (64 years old)
  • Recent Status Updates

    • Paul M.Murphy

      Paul M.Murphy

      Hello glad I got on this site. I hope to upload a couple of photos of my Simplicity Broadmoor 
      Model 707 Tractor. I have replaced all the belts on it and installed a new ignition switch.
      Have a mower deck which was in poor shape , repaced a couple of bushings and welded the
      deck where there was some holes. The tractor and mower deck came from a friend and the 
      mower deck metal was getting pretty thin. Some new metal was put in it and we also undercoated the underside of the deck. This was done by my friend Greg Toulman.
      I have not put the mower deck on the tractor yet, waiting for Greg to come home and give me a hand. Can you please tell me if there is a manual for the mower deck and where I could get one.
      I would also like to get some moon wheel discs as well.
      I will try and down load some photos of the tractor when my wife shows me how to. 
      I really love driving this tractor and also how well it is made compare today's tractors, especially the flexible rear end and the rollers.
      Tell the next time 
      · 8 replies
    • jbrooks

      jbrooks  »  Talntedmrgreen

      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
  • Adverts